
This note is part of the technical series and the full write-up is being prepared. Ask the export desk for the current version, and include the material and thickness you are working with so the reply matches your process.
Technical article · 05 Aug 2026
A seam that leaks usually has one section that ran too fast or with too little pressure, not a wrong current setting for the whole panel.

This note is part of the technical series and the full write-up is being prepared. Ask the export desk for the current version, and include the material and thickness you are working with so the reply matches your process.
Technical support
Settings differ with material, thickness and fixture. Send your workpiece details and the export desk will reply with a starting parameter set.
Ask a question